On a flat roof the water almost never comes in right above the drip. It gets in at a seam, a flashing, a drain or a curb, then runs along the deck or through the insulation until it finds a way down. That's why so many patches fail: they go over the stain, not the entry point.
Where flat roof leaks usually start
- Edges and copings: loosened by wind, especially on buildings exposed to the lake.
- Wall and parapet flashings: shrunk, cracked or never tall enough.
- Penetrations: pipe boots, pitch pockets, and curbs around rooftop units.
- Seams and laps: opened by age, freeze-thaw or poor original work.
- Drains: cracked bowls, loose clamping rings and clogged strainers.
- Punctures: from tools, shovels, debris and foot traffic around equipment.
How leaks are traced
Tracing starts inside: where the water shows up, when (rain, wind-driven rain, thaw), and how much. Then on the roof, we look upslope and around nearby details for the likely entry point, test suspect areas with water if needed, and take a core cut if we need to see what's happening below the membrane. On large roofs an infrared scan can map wet insulation. See leak detection and moisture surveys.
What the timing tells you
- Only in wind-driven rain: copings, counterflashing, edges and walls.
- Only during a thaw: frozen drains and ice backing water up. See ice dams on flat roofs.
- Every rain: a seam, puncture or flashing in the field.
- Days after rain: water stored in the insulation, slowly draining.
Roof leaking right now?
Manitowoc Superior Flat Roofing repairs, coats and replaces commercial and flat roofs across Manitowoc County and the lakeshore, with a written price before any work starts. Request a quote online and we’ll call you back.
What to do while you wait
Move stock, files and electronics away from the water. Shut off power to any wet light fixture or panel. Catch the water with buckets and plastic. Keep people away from a sagging ceiling. Don't send anyone onto the roof in wind, rain, darkness or ice.
What a proper repair looks like
The repair uses the roof's own material: EPDM tape and cover strips on EPDM, welded patches on TPO and PVC, matching plies on modified bitumen. Surfaces are cleaned and primed. Flashings are rebuilt to the right height. Tar smeared over the problem isn't a repair; it cracks within a season or two and makes the real repair harder.
Repair or replace?
Repair makes sense when the problems are at a few details and the insulation is dry. When leaks are everywhere, the insulation is wet over large areas, or the membrane is worn out, replacement or a recover is the better buy.