Manitowoc, WI & the Lakeshore Mon – Sat · Leak Calls 7 Days a Week
Home › Blog › Lakeshore
Lakeshore

Wind Damage on Flat Roofs Near Lake Michigan: What Fails and How to Prevent It

Along the Lake Michigan shore, wind has a long run over open water before it hits the first building. That's why the most common flat roof damage in Manitowoc, Two Rivers and the other lakeshore towns isn't hail or falling trees. It's edges, corners and copings worked loose by wind, and membrane peeled back once the wind gets underneath.

Why corners and edges fail first

When wind flows over a building, it creates suction on the roof. That suction is strongest at the corners and along the edges, and lower across the middle of the roof. Roof design standards account for this by requiring more attachment in the corner and perimeter zones. When a roof is built with the same fastening everywhere, or the edge metal isn't secured to a tested standard, the perimeter is where it lets go.

Once wind gets under the edge, every gust pulls a little more membrane loose. A small lifted corner in one storm can be a peeled-back section after the next.

Warning signs

  • Edge metal or gutters bent up, loose or missing.
  • Coping caps shifted or separated at the joints.
  • Membrane rippling, ballooning or fluttering when the wind blows.
  • Ballast stone swept into piles, with bare membrane at corners.
  • New leaks after a storm, especially along outside walls.
  • Fastener plates showing through the membrane near the edges.

Roof leaking right now?

Manitowoc Superior Flat Roofing repairs, coats and replaces commercial and flat roofs across Manitowoc County and the lakeshore, with a written price before any work starts. Request a quote online and we’ll call you back.

What to do after a big blow

  1. Look from the ground: edge metal, copings, anything hanging or missing.
  2. Check inside for new stains or drips, especially along exterior walls.
  3. Don't go on the roof in high wind. Have it walked once it calms down.
  4. Take dated photos and notify your insurer promptly if there's damage.
  5. Get the edge secured quickly. A temporary hold-down prevents bigger damage.

How a roof is built to stay on

  • Corner and perimeter attachment: tighter fastener spacing or extra half-sheets at the edges for fastened roofs; full adhesion where suitable.
  • Tested edge metal: the building code points to a tested edge-securement standard (ANSI/SPRI ES-1) for low-slope roof edges. Ask for edge metal that meets it.
  • Cleated copings: copings held by continuous cleats, not just sealant and a few screws.
  • Ballast design: paver or adhered details at corners where stone would scour.
  • Maintenance: a fall check of edges and copings before the November gales.

Insurance and documentation

Dated photos of the damage, taken soon after the storm, are the most useful thing you can give an adjuster. We document every storm call, secure the roof, and provide a written scope and price for the permanent repair. See wind and storm damage and emergency roof repair.


More roofing guides

Questions & Answers

Frequently asked questions

Wind flowing over a building creates the strongest suction at corners and along the perimeter. If edge metal or copings are loose, wind gets under the membrane and peels it back.

Check from the ground for bent or missing edge metal, and inside for new leaks. Have the roof walked if anything looks off, and keep dated photos for your insurer.

Sudden wind damage is often covered, but your policy decides. Prompt notice and good documentation help. See wind and storm damage claims.

Stone can be scoured off corners and edges in strong winds, leaving bare membrane. Those areas need to be re-ballasted or changed to an adhered or fastened detail.

Roof leaking?

Leak repair, coatings and replacement for commercial and flat roofs across Manitowoc County and the lakeshore. Tell us about the roof. You get a written price before any work starts.

Request a Quote