Manitowoc, WI & the Lakeshore Mon – Sat · Leak Calls 7 Days a Week
Home › Services › TPO Roofing
New TPO typically $6 – $12 per sq ft

TPO Roofing in Manitowoc, WI

TPO is the white single-ply membrane on most new commercial roofs in the country. Its seams are welded with hot air into one continuous sheet, it reflects summer sun off air-conditioned buildings, and it is competitively priced. A TPO roof is only as good as its welds and its attachment. Most TPO problems we see trace back to welds that were never probed, flashings that were cut short, fasteners pulling through near the edges where wind uplift is highest, and older first-generation sheets that have weathered thin. New TPO gets every weld probed, the corner and perimeter fastening the design calls for, and tapered insulation where the old roof held water. Repairs on aged TPO start with cleaning and a weld test, because some older membrane won't take a new weld and needs a different patch.

Written Price FirstBefore any work starts
Photo ReportsSee what failed and what we fixed
Every Low-Slope SystemEPDM, TPO, PVC, mod bit, BUR, metal
Leak Calls 7 DaysActive leaks dried in fast

What's included

  • New mechanically attached or fully adhered TPO roofs
  • Every seam probed after welding
  • Perimeter and corner fastening for wind uplift
  • Pre-molded corners, pipe boots and curb flashings
  • Weld repairs and patches on existing TPO
  • Weldability testing on aged membrane
  • Tapered insulation and crickets
  • Walkway pads to rooftop equipment
  • Warranty options explained in writing

Sound like your roof?

  • Seam edges that lift when probed
  • Membrane fluttering or billowing in wind
  • Fasteners showing through the sheet near edges
  • Chalky, thin or cracking white surface
  • Splits at corners and around curbs
Questions & Answers

TPO Roofing — FAQs

Commonly 15 to 25 years or more, depending on thickness, attachment, maintenance and how well water drains. See TPO vs. EPDM vs. PVC.

On air-conditioned buildings, offices, stores and plants with heat-producing processes, yes. On a building that mainly needs heat, the summer savings are smaller and EPDM is just as sensible. We’ll lay out both.

Usually. We clean the sheet and test whether it still welds. If it doesn’t, a compatible primed tape patch is used instead.

Roof leaking?

Leak repair, coatings and replacement for commercial and flat roofs across Manitowoc County and the lakeshore. Tell us about the roof. You get a written price before any work starts.

Request a Quote