Manitowoc, WI & the Lakeshore Mon – Sat · Leak Calls 7 Days a Week
Home › Services › EPDM Rubber Roofing
New EPDM typically $5.50 – $11 per sq ft

EPDM Rubber Roofing in Manitowoc, WI

EPDM, the black rubber sheet, is on a large share of the flat roofs along the Wisconsin lakeshore. It stays flexible well below zero, it doesn't crack from the constant freeze and thaw near the lake, and a good EPDM roof commonly lasts 20 to 30 years. When it fails, it fails at the details. Older glued seams let go. Flashings shrink away from walls and curbs. Edges and corners get worked loose by wind, especially on ballasted roofs where gusts have swept the stone into piles and left bare membrane. Shovels and dropped tools cut the field. We repair EPDM with compatible primers, seam tape and cured cover strips, and install new EPDM fully adhered, mechanically attached or ballasted to suit the building and its wind exposure.

Written Price FirstBefore any work starts
Photo ReportsSee what failed and what we fixed
Every Low-Slope SystemEPDM, TPO, PVC, mod bit, BUR, metal
Leak Calls 7 DaysActive leaks dried in fast

What's included

  • New EPDM roofs: fully adhered, mechanically attached or ballasted
  • Seams rebuilt with primer and tape, not caulk
  • Flashings at parapets, walls, curbs and pipes
  • Shrinkage and bridging at edges and corners corrected
  • Wind-loosened perimeters re-secured and re-flashed
  • Ballast stone redistributed and bare areas repaired
  • Punctures and shovel cuts patched
  • EPDM on porches, garages and additions
  • Warranty options explained in writing
Triangular puncture in a ballasted EPDM roof membrane with the river-rock ballast raked aside
A puncture hidden under the rock on a ballasted EPDM roof. The ballast had to be raked back to find it.
The same EPDM puncture cleaned, primed and covered with a rounded rubber patch sealed at the edges
The same spot repaired: cleaned, primed, a rounded EPDM patch rolled on and the edge sealed, then the ballast goes back.

Sound like your roof?

  • Seam edges curling open
  • Membrane drawn tight across a corner or pulled off a wall
  • Ballast swept into piles with bare rubber showing
  • Cuts after snow removal
  • Several old glued seams leaking at once
Questions & Answers

EPDM Rubber Roofing — FAQs

Commonly 20 to 30 years. Cold doesn’t hurt EPDM much; seam quality, drainage, foot traffic and how well the edges are secured matter more. Compare systems in TPO vs. EPDM vs. PVC.

Usually. Aged EPDM can be cleaned and primed so new tape and patches bond to it. If it has shrunk badly or the insulation under it is wet over large areas, replacement is the better buy.

Not if it was designed for the exposure, but wind can scour stone from corners and edges. Those areas need to be checked and re-ballasted or converted to an adhered or fastened detail.

Roof leaking?

Leak repair, coatings and replacement for commercial and flat roofs across Manitowoc County and the lakeshore. Tell us about the roof. You get a written price before any work starts.

Request a Quote